Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 122 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 122 2019-08-05
Synchronous Response
Table 100, page 122 describes the synchronous responses and remarks for the Set WPS
command.
Example 1 AT+P2PSETWPS=Debvice
ID,0006,0001,11223344556677881122334455667788
OK
5.4.3 Start Find
This command is used to transition the device in to P2PFIND phase.
Command Syntax AT+P2PFIND=<Timeout>,<Channels to scan in search
state><CR>
Parameter Description
Table 101, page 123 describes the Start Find parameters.
Table 99 Set WPS Parameters
Parameter Optional/Mandatory Value Description
Device name Mandatory
32 bit character.
default value
(GAINSPAN-P2P)
Unique name to identify the device. P2P
Device manufacturers should attempt to
create unique Device Names and user
interfaces that maximize the probability of
selecting the correct device, but there will be
cases where device selection is
non-deterministic.
Primary device type
category ID
Mandatory 2-byte A device category value.
Primary device type
subcategory ID
Mandatory 2-byte A device subcategory value.
UUID Mandatory 16-byte Universally unique identifier.
Note: GS2000 does not support configuring secondary device type subcategory ID.
Table 100 Set WPS Synchronous Responses
Events Verbose mode Non Verbose mode Remarks
Success <CR><LF>OK<CR><LF> <CR><LF>0<CR><LF> All parameters are valid.
Failure
<CR><LF>ERROR:<SP>INVALID<SP>INPUT
<CR><LF>
<CR><LF>2<CR><LF> Parameters are valid.