Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 162 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 162 2019-08-05
8.1.1.3 Gain Control Table
8.1.1.4 Start RF Test
This command is used to enable the radio test mode.
Command Syntax AT+WRFTESTSTART
8.1.1.5 Stop RF Test
This command is used to disable the radio test mode.
Command Syntax AT+WRFTESTSTOP
8.1.1.6 Asynchronous Frame Transmission
This command is used to enable the frame transmission. This command enables the
asynchronous data transmission with the parameters configured. After issuing this
command the transmission will go with the default payload.
Command Syntax AT+WFRAMETXTEST=<Channel>,<BandWidth>,<NumFrames>,<FrameL
en>,<TxRate>,<TxPower>,<DestAddr>,<Bssid>,<HtEnable>,
<GuardInterval>,<GreenField>,<PreambleType>,<QosEnable>,
<AckPolicy>,<Scrambler>,<AifsnVal>,<Antenna>,<ccaBypass>
Parameter Description
Table 144, page 162 describes the Asynchronous Frame Transmission parameters.
Table 143 Gain Control Table
Data Rate 1 Mbps 2 Mbps 5.5 Mbps 11 Mbps 6 Mbps 9 Mbps 12 Mbps 18 Mbps 24 Mbps 36 Mbps
GCT 18 8 14 11 27 27 27 27 26 25
Data Rate 48 Mbps 54 Mbps MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7
GCT 24 19 27 27 27 27 25 24 20 16
Table 144 Asynchronous Frame Transmission Parameters
Parameter Optional/Mandatory Value Description
Channel Mandatory 1-14
The channel on which the data to be
sent (1-14).
BandWidth Mandatory 0 The values of 0 is 20MHz.
Note: The GS node currently supports 20MHz operation.
NumFrames Mandatory 1-65535
The number of asynchronous frames
to be sent (1-65535).