GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 165
2019-08-05
Example
Serial2WiFi APP
AT+NMAC=?
00:1d:c9:17:8d:b1
OK
AT+WRFTESTSTART
OK
AT+WRXTEST=6, 0, 429493010, 00:1d:c9:17:8d:b1, 0
Ok
AT+WRXSTOP
No of packets recieved = 6988
No of byte recieved = 6988000
No of packets received with CRC Errors = 6933
No of packets received with Security Errors = 0
No of duplicate packets received = 0
No of header errors received = 237
Average RSSI of the received packets = -21
No of packets received at 1M and Long Preamble = 0
No of packets received at 2M and Long Preamble = 0
No of packets received at 5M and Long Preamble = 0
No of packets received at 11M and Long Preamble = 0
No of packets received at 2M and Short Preamble = 0
No of packets received at 5M and Short Preamble = 0
No of packets received at 11M and Short Preamble = 0
No of packets received at 6M = 0
No of packets received at 9M = 0
No of packets received at 12M = 0
No of packets received at 18M = 0
No of packets received at 24M = 0
No of packets received at 36M = 0
Table 146 Asynchronous Frame Reception Start Parameters
Parameter
Optional/Mandatory
Value
Description
Channel
Mandatory
1 to 14
The channel on which the data is to be
sent (1-14).
BandWidth
Mandatory
0
The values of 0 is 20MHz.
Note:
Currently supports only 20MHz operation.
RxFrameTypeFilter
Mandatory
32-bit
This is a 32-bit variable, where each
bit corresponds to one type of packet
filter.
RxAddrFilter
Mandatory
N/A
The MAC address of the GS node is
same as the Destination address.
Note:
The Rx filter is based on destination address. For PER test, transmit from another GS node or some other
source specifying the destination address and set up the receiver to receive frames only destined to its address.
Receiver can be set up to receive all frames by setting filter to zero but that’s not useful for PER because you don’t
know how many frames were sent. Source address based filtering is not supported.
Antenna
N/A
N/A
Not supported
