Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 118 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 118 2019-08-05
Synchronous Response
Table 95, page 118 describes the synchronous responses and remarks for the WLAN Keep
Alive Interval command.
5.3.8 Advanced Commands
5.3.8.1 Get Client Information
This command is used to get information about the clients associated to the module when
it acts as a limited AP.
Command Syntax AT+APCLIENTINFO=?
Synchronous Response
Table 96, page 119 describes the synchronous responses and remarks for the Get Clients
Information command.
Table 94 WLAN Keep Alive Interval Parameters
Parameter Optional/Mandatory Value Description
Interval Mandatory
0 to 255 seconds This parameter specifies the time GS node
keeps sending NULL frame to AP to
maintain the association.
The value 0 disables this feature.
45 seconds (default)
Type Optional Value range: 0,1
It specifies whether the timer for the above
mentioned interval is maintained across
standby or not.
• 0 (Non-persistent): If this parameter is not
set or set to 0, the keep alive will work only
in Always ON scenario by sending a NULL
frame but not across standby as this is
handled by WLAN.
• 1 (Persistent): If this parameter is set to 1,
then the timer is maintained across standby.
Once GS node wakes up after the specified
an ARP frame is sent periodically in Always
ON and standby both scenarios as this is
handled by Application.
Table 95 WLAN Keep Alive Interval Synchronous Responses
Responses Remarks
OK Success
ERROR:INVALID INPUT If parameters are not valid