Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 144 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 144 2019-08-05
beacons, set by the Access Point configuration. Many Access Points default to 100msec
between beacons; in most cases this parameter can be adjusted.
6.2 Battery Measurement
6.2.1 Battery Check Start
This command is used to send out a unit of battery check frequency in number of packets
from the IP-to-WiFi Application, and store the resulting values in nonvolatile memory.
Only the most recent value is stored. Battery checks are performed during packet
transmission to ensure that they reflect loaded conditions. Battery checks can be used to
ensure that a battery-powered system is provided with sufficient voltage for normal
operation. Low supply voltages can result in data corruption when profile data is written to
flash memory.
Command Syntax AT+BCHKSTRT=<Frequency>
Parameter Description
Table 122, page 144 describes the Battery Check Start parameters.
Synchronous Response
Table 123, page 144 describes the synchronous responses and remarks for Battery Check
Start command.
Table 122 Battery Check Start Parameters
Parameter Optional/Mandatory Value Description
Frequency Mandatory 1-100 packets
It specifies the number of packets GS
node sends before performing the
battery check.
Example: When Frequency is
configured as 10, GS node performs
the battery check after every 10
packets are transmitted.
Table 123 Battery Check Start Synchronous Responses
Responses Remarks
OK Success
ERROR:INVALID INPUT If parameters are not valid.