Telit Wireless Solutions GS2101M Series, Command Reference Manual

Page: 157 / 196

GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0 157 2019-08-05
6.3.4 Power Save in Limited AP
This command is used to configure power save in Limited AP Mode.
Command Syntax AT+WAPPSCFG=<Power-Save
Configuration>,<Reserved>,<Receiver on-time after
Tx>,<Power-save behavioral control>
Usage
When enabled, the module will enter the power saving mode when no actions are pending.
In power save mode, the processor clock is turned OFF, and the module power consumption
is reduced.
Parameter Description
Table 138, page 157 describes power save in Limited AP Mode parameters
Table 138 Deep Sleep in Limited AP Mode parameters
Parameter Optional/Mandatory Value Description
Power-Save Configuration Mandatory 0,1
This parameter decides the state of
radio (on/off) in conjunction with
‘Power-Save Control’ parameter.
Reserved parameter Mandatory 0
Always issue zero (0) for this
parameter.
Receiver on-time after
Transmission
Mandatory
0 to Beacon
interval
Unit:
millisecond
It specifies the time the receiver will
be kept on after any transmission
(beacon).
Receiver on-time after
Transmission (Contd)
Example: When this parameter is
configured as 10, the receiver will be
switched on for 10 milliseconds after
transmitting the beacons.
Note:
a> If system decides to transmit a
frame in the mean time (within 10ms
as mentioned in the above example),
then receiver on-time will restart from
that instant.
b> Maximum ‘Receiver on-time after
Transmission’ should not exceed
beacon interval.
Power-save behavioral control Mandatory 0,1
This parameter decides the state of
radio (on/off) in conjunction with
‘
Power-Save Configuration ’.
Refer to the Table 139, page 158 .