GS2101M IP2WiFi Adapter Command Reference Guide
1VV0301499
Rev. 2.0
158
2019-08-05
The following table provides the behavior of an AP corresponding to the combination of
values configured for Power-save control and Power-save configuration parameters.
Synchronous Response
describes the synchronous responses and remarks for Deep Sleep in
Limited AP mode command.
6.3.5 Hardware Cryptography
This command is used to enable or disable hardware cryptography block. This feature is
used when user uses security features such as SSL, WPS, EAP, and so on. Hardware
cryptography is enabled by default in IP to WiFi.
Table 139 AP behavior based on Power-Save Control and Power-Save Configuration
Power-Save Control
Power-Save Configuration
0
1
0
Exit power save immediately.
(Radio will be switched on
immediately)
Note:
Exits power save only
after all pending transmit and
receive events.
Enter power save immediately.
(Radio will be switched off
immediately)
Note:
Enters power save only after all
pending transmit and receive events.
1
Exit power save at the next
TBTT (beacon interval).
Enter power save only after all
associated clients are in power save.
Note:
System will exit power save as
soon as any one of the STAs exit the
power save mode, but will not
automatically re-enter the power save
state. This is supported only from
5.2.x.
Table 140 Deep Sleep in Limited AP Mode Synchronous Responses
Responses
Remarks
OK
Success
ERROR
Failure
ERROR:INVALID INPUT
If parameters are not valid.
