Section D – Tester Installation
CD14 Tester & CD AutoPlus Autosampler User Guide—75-108-800 Rev. B—31 May 2021
22 of 130
EAR99 technology subject to restrictions on cover page.
General Unpacking and Installation
The CD14 Tester has been shipped in a one-use, disposable
shipping container. Prior to unpacking, the shipment should be
located in an area that allows working room around the
container. Vertical clearance will be needed to remove the
mast covers up and over the unit to gain access to the
counterweight lock screws. It’s best to do this as close to the
final installation site as possible.
Unpacking the CD14 Tester
1.
Prior to unpacking, note any damage to the
container. If the container is damaged, contact the
shipping company and Teledyne Hanson before
proceeding.
2.
Remove the straps and open the top of the
cardboard box.
3.
Remove any inside packaging and as many small
items as can be accessed from the top opening.
4.
Pull the outside cardboard box up and over the unit.
5.
Remove all remaining loose items and packaging.
6.
Cut the corners of the bottom cardboard tray and
fold down the four sides of the tray.
7.
Remove the heater enclosure out from under the
unit.
