TeleChips TCC720, User Manual

Page: 7 / 143

TCC720
INTRODUCTION
32-bit RISC Microprocessor for Digital Media Player
Dec. 16. 2002
Preliminary Spec 0.51
1 - 4
1.2 Pin Description
JTAG Interface
Signal Name NUM Type Description
TDI 99 I JTAG serial data input for ARM940T
TMS 100 I JTAG Test mode select for ARM940T
TCK 101 I JTAG test clock for ARM940T
TDO 102 O JTAG serial data output for ARM940T
nTRST 103 I Reset signal for boundary scan logic. Active low.
External Memory Interface
Signal Shared Signal NUM Type Description
SD_CKE GPIO_B0 56 O Clock enable signal for SDRAM, Active high. / GPIO_B1
SD_CLK GPO 44 O SDRAM clock
SD_nCS GPIO_B1 46 O Chip select signal for SDRAM, Active low. / GPIO_B0
XA[6:0] - 23:17 O
XA[12:7] - 31:26 O
Address bus for external memories.
XA[13] SD_BA0 34 O Bank Address 0 for SDRAM / XA[13]
XA[14] SD_BA1 35 O Bank Address 1 for SDRAM / XA[14]
XA[15] SD_nCAS 36 O CAS for SDRAM / XA[15]
XA[16] ND_ALE, SD_nRAS 37 O ALE for NAND flash / RAS for SDRAM / XA[16]
XA[17] ND_CLE 38 O CLE for NAND flash / XA[17]
XA[19:18] - 40:39 O XA[19:18] for static memory / Bus Width configuration
XA[21:20] DQM[0:1] 43:42 O XA[21:20] / Data I/O mask
XD[15:9],
XD[8:4],
XD[3:0]
XD[15:9],
XD[8:4],
XD[3:0]
15:9,
6:2,
128:125
I/O Data bus for external memory
nCS0 / ND_nOE0 GPIO_B2 47 O External chip select 0 / NAND flash 0 OE / GPIO_B2
nCS1 / ND_nOE1 GPIO_B3 48 O External chip select 1 / NAND flash 1 OE / GPIO_B3
nCS2 / ND_nOE2 GPIO_B4 49 O External chip select 2 / NAND flash 2 OE / GPIO_B4
nCS3 / ND_nOE3 GPIO_B5 50 O External chip select 3 / NAND flash 3 OE / GPIO_B5
IDE_nCS1 GPIO_B9 / UT_RX 61 O IDE chip select 1. Active low. / GPIO_B9 / UART RX
ND_nWE GPIO_B7 57 O NAND flash WE. Active low. / GPIO_B7
nWE nWE 58 O Static memory write enable signal. Active low.
nOE nOE 59 O Static memory output enable signal. Active low.
READY - 73 I Ready information from external device.
*) XA[21:0] is used as system address bus for external memories such as SRAM, ROM.
XA[12:0] can be also used as RAS and CAS signals for SDRAM.
XD[15:0] is used as system data bus for all types of external memories contained.
SD_CLK is also used as general purpose output port by setting clock control flag. Refer to the
chapter of memory controller for detail.