Tektronix WFM2200A, User Manual, Page: 72 / 276

Measure pop-up menu
(ANC Data display)
Press and hold the MEAS button to open the Measure pop-up menu. The pop-up
menu enables you to configure the display type and configure display parameters
for the different display types. The following menu selections are available:
Display type.
Select from the following display types:
■ Timing Measure - Displays a Tektronix proprietary view that enables you to
easily compare and correct the timing between two signals. See Timing
Measure display on page 136.
■ Datalist (Option DATA only) - Displays the content of all digital signal
formats, structures, and transports (SD, HD, 3G, dual link, 4:2:2, 4:4:4, and
others) except for composite signals. See
Datalist display (Option DATA
only) on page 83 .
■ Bowtie - Displays the interchannel timing between Y Pb and Y Pr. See
Bowtie display on page 81.
■ ANC Data (Option DATA only) - Displays all of the ANC data in a video
signal.
■ AV Delay (Option AVDP only) - Displays results of the AV Delay and
Propagation Time measurements. See AV Delay Measurement display
(Option AVDP only) on page 78.
■ ASI PID List Disp. (WFM2300 Option ASI only) - For MPEG2 transport
stream inputs, displays the MPEG TS PID tree with each stream element
having an LED icon to indicate the status of the element. See
ASI PID List
display (WFM2300 Option ASI only) on page 54.
All sessions reset. Select this option and press the SEL button to globally reset all
of the displayed ANC Data display sessions. The session time is set to zero and
all errors (if present) are reset.
View mode.
Select the view mode:
■ All - Displays all of the ANC data types present in the video signal.
■ Watch list - Displays only the ANC data types selected by the user in the
Watch List. See To configure the Watch List on page 51.
CONFIG menu
Use the CONFIG menu to set the following ANC Data display parameters:
■ Use the ANC Data Display > User ANC Types settings to define the ANC
data types by name and DID/SDID values.
■ Use the ANC Data Display > Config Watch List selection to select which
ANC data types will be displayed. See To configure the Watch List on
page 51.
■ Use the Aux Data Settings selections to define the ANC data types by name
and DID/SDID values.
■ Use the menu selections under Alarms to enable the alarms for various types
of ANC data errors.
Display modes
50 WFM2300 and WFM2200A Waveform Monitors User Manual