Tektronix WFM2200A, User Manual, Page: 261 / 276

Network access
Network access can be controlled by parameters in the CONFIG menu under the
Network Settings submenu. These settings allow you to enable or disable access
through the network, set community strings, and set addresses. See
Configure the
network interface on page 20.
NOTE. Some Web browsers interpret IP addresses with leading zeros as octal
numbers. For example, if the address of the instrument is of the form
124.161.038.151, then enter it in the browser as 124.161.38.151.
SNMP control
SNMP control is primarily intended for access by means of automation systems.
The complete SNMP MIB can be downloaded from the instrument Web page.
You can also download a printable version of the MIB from the Tektronix Web
site: www.tektronix.com/manuals.
SNMP Traps can be sent to up to four addresses when error conditions are
detected. See
Configure the network interface on page 20.
Use the CONFIG menu to set various parameters that will generate SNMP trap
error reports. Some of those parameters are listed below.
■ Use the menu selections under Gamut Thresholds to set the minimum and
maximum gamut limits for composite signals derived from the SDI signal,
set the minimum and maximum luma levels, and specify the percentage of
the total image pixels that can be outside the current gamut or luma limits
and not generate error reports.
■ Use the menu selections under Alarms to enable various alarms that will be
reported in the log.
■ Use the menu selections under Aux Data Settings to set various expected
data parameters.
Remote Web interface
WFM2300 and WFM2200A Waveform Monitors User Manual 239