Tektronix WFM2200A, User Manual

Page: 39 / 276

SFP module transportation.
The SFP module should be removed from the
waveform monitor while the instrument is being transported.
CAUTION.
To prevent static damage to the SFP module while you are
transporting the waveform monitor, always transport the SFP module in a anti-
static bag or container.
Video system installation
The instrument can operate almost anywhere in the distribution system where
serial digital system monitoring is needed.
Line termination. The line termination of the signal inputs are as follows:
■ SDI A and REF IN : Each input has a 75 Ω internal termination.
■ MULTI IN : The input auto-terminates based on the type of input signal.
■ SFP (optional) : The termination of the optional SFP input is determined by
the installed module. No termination occurs for optical inputs.
Compatibility of BNC center pins.
Most BNC connectors for video equipment,
whether 50 Ω or 75 Ω, use a 50 Ω standard center pin. Some laboratory 75 Ω
BNC connectors use a smaller diameter center pin. The BNC connectors on the
instrument are designed to work with the 50 Ω standard (large diameter) center
pins.
Do not use connectors or terminators with the smaller center pins. They could
cause intermittent connections.
To monitor the video bit stream of a serial receiver.
Route an incoming serial
signals into the SDI A or MULTI IN input on the instrument.
NOTE. See the WFM2300 and WFM2200A Specifications and Performance
Verification Technical Reference for the maximum allowed cable lengths.
Getting started
WFM2300 and WFM2200A Waveform Monitors User Manual 17