Tektronix WFM2200A, User Manual

Page: 55 / 276

■ MEAS : display of various measurements, including timing, audio video
delay, propagation time, ANC data, and Data List
■ GEN : display of status and configuration of the video generator and audio
generator or view information from the Diagnostics Monitor
■ PHY (WFM2300 only) : display of Eye display, Jitter display, and Litter
Meter, and access to SDI Stress Loop amplitude parameter and Jitter HP
filter settings.
Display limitation
The instrument is capable of showing only two of the following displays at a
time: Waveform, Vector, Lightning, Arrowhead, Diamond, Split Diamond,
Bowtie, Datalist, Eye, and Timing Measure. A warning messages appears when
you try to open more than two of these displays.
Pop-up menus All pop-up menus are displayed by pressing and holding the specified display
button for three seconds. To hide a pop-up menu, press the specified button
again. Pop-up menus appear in the active tile and, in general, control only
settings specific that tile. A pop-up menu will not appear if it is not appropriate
for the current instrument setting.
To set display parameters
Use the pop-up menus to set up the measurements that you display.
1. Select a tile by pressing the Display Select button.
2. Press and hold a display button and the display and the pop-up menu for that
display appears.
NOTE.
The selections in a pop-up menu can change depending on settings.
3. Use the right and left keys to move between menu panels. The instrument
surrounds the panel selected with a blue border.
4. Use the up and down arrow keys to select parameters in a menu.
Figure 2: Navigate menus using the arrow keys and select button
5. Navigate through the menu and make your selections.
Getting acquainted with your instrument
WFM2300 and WFM2200A Waveform Monitors User Manual 33