3.
Assign the instrument an IP address:
NOTE.
When the instrument is connected to your local network, the
instrument must be assigned a valid IP address to operate on your network.
The instrument is shipped with a default IP address of 192.168.1.1, but the
address will usually not be valid on your local network.
The network addresses of the instrument can be assigned either manually or
automatically using DHCP. If your network does not use DHCP, you will
have to manually enter the address for the instrument. In that case, contact
your local LAN administrator to obtain the valid network addresses.
Alternatively, when you connect the computer directly to the instrument using
an Ethernet cable, you can manually assign the instrument any IP address
that is compatible with the IP address for the Ethernet interface of the
computer.
a.
Press the
CONFIG
button on the front panel.
b.
Navigate to
Network Settings
>
IP Config Mode
.
c.
Set the IP configuration mode:
■
If you connected the instrument to your local network, select either
Manual
or
DHCP
as directed by your LAN administrator.
■
If you connected the instrument directly to your computer, select
Manual
.
d.
If you set the IP configuration mode to Manual, perform one of the
following tasks:
■
If you connected the instrument to your local Ethernet network, enter
the IP address, subnet mask, and gateway address as directed by your
LAN administrator.
■
If you connected the instrument directly to your computer, enter an
IP address that is compatible with the IP address for the Ethernet
interface of the computer. For example, if the IP address of the
computer is 199.55.142.12, then set the IP address of the instrument
to 199.55.142.x, where x ≠ 0, 12, or 255.
Set the subnet mask to the same value used by the computer. Set the
gateway address to be the address of the computer.
NOTE.
If you selected DHCP mode, the network automatically assigns
the instrument an IP address. DHCP typically requires several seconds
to assign the network address.
e.
Press the
CONFIG
button on the front panel to close the menus.
Getting started
WFM2300 and WFM2200A Waveform Monitors User Manual
21
Summary of Contents for WFM2200A
