Getting Started
1Ć6
MTX100 MPEG Recorder & Player User Manual
The instrument does not have a power switch, but does have an
on/standby switch. When you connect the power cable to the AC line connector,
power is applied to the power supply standby circuit of the instrument. Read all
instructions before plugging the power cable into a power source.
Refer to Table 1-3 on page 1-3 to verify that you are using the proper power
cord for your location. Connect the power cord from the rear-panel power
connector to the power system.
The instrument is shipped with a power cord appropriate for use with
your power systems (normal 115 V power system or 230 V power system). If the
instrument is to be used with a power system other than what the order specified,
the power cord must be replaced with one appropriate for the power source
used. Refer to Table 1-3 for a listing of available power cords.
After you have verified the operating environment, AC line, and power cord
requirements, plug the power cord into the power connector on the rear panel
(see Figure 1-1), and then plug the power cord into the local power source.
Power On.
Press the ON/STBY switch (see Figure 1-2) to power on the
instrument. After you power on the instrument, verify that the fan on the rear
panel is operating. To verify that the fan is operating, place your hand behind the
right side of the instrument. The fan’s air flow should be felt.
Do not operate the instrument if the cooling fan does not operate
when you turn the instrument on. Serious damage to your instrument can occur
from overheating if the cooling fan is not operating.
. Allow the instrument to warm up for 20 minutes prior to calibrating the
clock. The instrument must be completely warmed up to operate at its optimum
precision.
Power Cord Requirements
Applying Power to the
Instrument
Summary of Contents for MTX100
