Tektronix CSA7154, User Manual

Page: 55 / 480

Incoming Inspection
CSA7000 Series, TDS7000 Series, & TDS6000 Series Instruments User Manual
1- 33
1. Initialize the instrument: Push the front-panel DEFAULT SETUP button.
2. Hook up the signal source: Connect the equipment to the CH 1 input as
shown in Figure 1--11.
CSA7404, CSA7154, TDS7404, TDS7254,
TDS7154, TDS6604, & TDS6404
BNC cable from PROBE
COMPENSATION output
to CH 1 input
TDS7104 & TDS7054
BNC cable from PROBE
COMPENSATION
output to CH 1 input
Figure 1- 11: Setup for the file system test
3. Insert the test disk: Insert the floppy disk in the floppy disk drive at the top
of the front panel.
4.
Set up the instrument:
Push the front-panel AUTOSET button.
5.
CSA7404, CSA7154, TDS7404, TDS7254, TDS7154, TDS6604, &
TDS6404:
Touch the
Vert button and then touch Offset . Adjust the Ch1 Offset to 0.8 V
using the multipurpose knob.
6. CSA7404, CSA7154, TDS7404, TDS7254, TDS7154, TDS6604, &
TDS6404:
Set the Vertical
SCALE
to
100 mV
per division.
7. Set the time base: Set the horizontal SCALE to 1 ms/div . The time-base
readout is displayed at the bottom of the graticule.
8. Save the settings:
a.
Pull down the
File
menu to select
Instrument Setup . . .
. This displays
the instrument setups control window.