Tecnoalarm TP8-96, Installer Manual, Page: 70 / 118

Time parameter configuration Installer Manual - TP8-96 VIDEO
4-4
Associated programs or remote controls
To associate the timers to the programs or remote controls
press the key below the number key. It is possible to associate
a total of 8 programs and 8 remote controls to every timer.
Repeat the procedure for every timer to be configured.
Associate a total of 8 programs or 8 remote controls by clicking
on the corresponding item.
The number displayed in the item confirms the association.
Warning: It is only possible to select either programs or
remote controls, never both together.
Repeat the procedure for every timer to be configured.
TEST CALL
Permits the remote functioning check of the control panel. It
consists in one or several telephone calls made by the channels
the test call is associated to (see report codes) to the
programmed telephone numbers
The calls are made at a determined time with a programmed
frequency.
To enable the test call check the corresponding item.
The following parameters can be set for every timer:
z
Hour of activation
z
Frequency of activation
z
Condition
Starting hour of the test call cycle
To program the starting hour of the test call cycle, select the
item next to
Start and enter the time (hh:mm).
Frequency
To program the frequency of the test call, enter a value from 1 to
255 and select the time unit from the drop-down menu (i.e.
minutes, hours or days) as indicated in the beside figure.
Condition
Select from the drop-down menu the activation condition of the
timers: always or armed (i.e. only if at least one program is
armed).
TEST CALL SERVER
Permits the periodic and automatic control of the presence of
the Ethernet connection between control panel and the
Tecnoalarm software.
The test is executed via Ethernet with a TCP/IP protocol.
Frequency
To program the frequency of the test call server, enter a value
from 1 to 255 and select the time unit from the drop-down menu
(i.e. minutes, hours or days) as indicated in the beside figure.
Channel
Select the channel (A...H) which will execute the test. Make
sure that the channel in question uses the TCP/IP Tecnoalarm
data protocol (number code 192).
Store in the event log
Enables/disables the storage of the test call server in the event
memory of the control panel.
Check the item to enable the storage.
See § 4.5 for explanatory notes.
Press:
z
OK to confirm and quit
z
Abandon to quit without saving