Tecnoalarm TP8-96, Installer Manual, Page: 50 / 118

Telephone section configuration Installer Manual - TP8-96 VIDEO
3-6
3.1.3 TECNOCELL
Select the Tecnocell table.
On the screen is viewed:
TECNOCELL
The Tecnocell configuration table permits enabling and programming of the external GSM telephone communicator.
z
Enabling
If enabled, the external GSM telephone communicator signals the alarms to the control panel in case of failure of the
integrated GSM module (primary channel).
z
Answering
If checked, the GSM telephone communicator answers incoming calls transmitting one of the two prerecorded
system status messages (control panel in stand-by or alarm active). By default, the GSM telephone communicator
answers after 3 rings.
The message is repeated until communication shutdown.
z
Emergency phone number
The GSM telephone communicator communicates constantly via RS485 serial bus with the control panel. If the
communication is interrupted (serial bus badly connected or missing) for more than 30 seconds, the GSM telephone
communicator makes an emergency voice call at the programmed number (max. 17 digits) transmitting the selected
emergency message.
Enter the emergency number in the item.
z
Message
Program the message to be sent during the emergency call by entering the number (1 to 4) in the item.
Warning: This function is available only if the GSM telephone communicator is equipped with the
optional voice messages board VOICE.
PRO (only for the TECNOCELL-PRO PL)
z
Number of rings
The number of rings prior to answering to incoming calls is programmable from 3 to 15.
By default, the telephone communicator with GSM module answers after 3 rings.
z
Emergency SMS
Enabling of the emergency SMS cancels the emergency voice call.
If the emergency SMS function is enabled and if the communication via RS485 serial bus with the control panel is
interrupted (serial bus badly connected or failed) for more than 30 seconds, the GSM telephone communicator
sends an emergency SMS (max. 80 characters) to the programmed emergency number.
Check the item to enable the emergency SMS and enter the message to be transmitted.
The text of the message to be transmitted is programmed by default but can be modified.