Tecnoalarm TP8-96, Installer Manual, Page: 104 / 118

Special procedures Installer Manual - TP8-96 VIDEO
A-4
A.2 DELETION OF THE ENTIRE SYSTEM
CONFIGURATION (RESET OF DEFAULT SETTINGS)
This procedure permits the deletion of the entire system configuration and setting of
the default settings.
Warning: Before you reset the configuration, always make sure that it is really
necessary and that the control panel is in stand-by (date and time displayed). If
need be, make a copy of the configuration of the control panel.
Here below the procedure for the deletion of the system configuration.
z
Remove the jumper JP9
z
Insert the jumper JP3
z
The red, yellow and green LED of the electronic board are switched off
z
On the display of the console Line ! ABSENT ! is viewed and all the LED of the
console are blinking
z
When the firmware version of the system will be viewed, press the star key
(
*
NO ) several times.
On the display is viewed Config. Deleted .
z
Reinsert the jumper JP9
z
Remove the jumper JP3 and verify that the yellow LED is switched on.
After a few seconds, the control panel returns to stand-by and on the display
reappears date and time signaling.
Warning: After the deletion of the system configuration, the control panel will be
set with all the default settings (i.e. no telephone number, no zone
configuration, no function programmed) and the default codes as well as the
default code length:
z z z z z
Default installer code 54321
z z z z z
Default master code 12345
z z z z z
Default standard user codes 00000 (unvalid code)
z z z z z
Default code length 5 digits
(c) Tecnoalarm
Ver 0.7.05 ENG
Tue 12 JAN 10
Work. 10:45
Config.
Deleted
Tue 12 JAN 10
Work. 10:45
Line
! ABSENT !