Tecno-gaz ORION TECH, Operation And Maintenance Manual

Page: 59 / 156

Operation and
maintenance manual
MU_029_EN 07/11/18
EN
Rev.0 Page 21 of 35
7.4 Routine maintenance
Interrupt the power supply before doing any maintenance jobs.
Check Product integrity
N Period Action
1 Before using
Make sure there are no pieces or fragments of paint that could
become detached and fall within the operating field. If there are
any, remove them manually.
2 Before using
Make sure the light source protection screens are not damaged. If
they are, contact the Customer Service.
3 Once a year
Check all the Product joints and make sure there are no noises or
squeaks. If there are, lubricate the clutches involved with suitable
grease for industrial use at a service temperature between -30°C
and + 120°C, type OKS 470 or with similar properties.
4 Once a year
If the Product fails to maintain a regular position, adjust the
clutches as indicated at points
7.1 and 7.2 (arm and clutch
adjustment)
.
5 Once a year
(CEILING VERSION)
Make sure the bar retention screws (1) are tightened properly. Also
check the bar horizontal arm retention screws (4). If these are not
properly fastened, adequately tighten.
See drawing 200
. To access the nuts (1), slide off the aluminium
ring (2) downwards by loosening the screws and bar cover (3).
6 Once a year
(FLOOR VERSION)
See drawing 200
. Floor version: Make sure the stem retention
screws (5) under the base are tightened properly.
If these are not properly fastened, adequately tighten.