51
9-3. Clear Digital Zero
You can restore the zero setting that has been used before
Digital Zero was performed.
After this function is performed, the TD-260T displays the
current sensor input value, regarding as zero the sensor
input that was observed when the zero-point calibration was
performed.
1. Enter the setup screen number F1-14.
Press once
Press twice
2. To clear the digitally set zero, press ENTER. To exit
the setup mode, press ESC.
9-4. Enable Digital Zero
With Enable Digital Zero set to OFF, a reading cannot be
digitally set to zero if you press ZERO or short-circuit the
control input/output terminals A8 for D/Z and A9 for COM.
1. Enter the setup screen number F3-1.
Press 3 times
2. To select ON or OFF, press
5
or
b
.
or
3. To save the selection, press ENTER, and then to exit
the setup mode, press ESC.
To save, press:
9. Digital Zero Function