40
7-10. SET Lock
You can prevent changes to settings you have saved.
For detailed information about the applicable setup items, see
the section 4-2. “List of setup items and settings.”
1. Enter the setup screen number F3-6.
Press 3 times
Press 3 times
2. To select OFF or ON, press
5
or
b
.
or
3. To save the selection, press ENTER, and then to exit
the setup mode, press ESC.
To save, press:
7-11. Static Strain Mode
You can display the input signal in microstrains.
By selecting this mode, you can check for sensor output or
fluctuations in the reading and other erroneous phenomena
caused by parts including sensor and cable.
1. Enter the setup screen number F3-7.
Press 3 times
Press twice
2. To select OFF or ON, press
5
or
b
.
or
3. To save the selection, press ENTER, and then to exit
the setup mode, press ESC.
With ON selected, the input signal is displayed in
microstrains.
To save, press:
NOTE
<
To exit the static strain mode, select OFF while the above
screen is displayed, or shut off the power to the TD-260T,
and then turn it on again.
<
The TD-260T uses one strain gage with a gauge factor of 2.0
to display static strain.
7. Setting Functions