TDK-Lambda GENESYS 10KW, Technical Manual

Page: 29 / 74

83-530-000 Rev G
26
Table 4-1: Front Panel controls and indicators
Number Control/Indicator Description Section
1 VOLTAGE control High resolution rotary encoder for adjusting the Output
Voltage. Also adjusts the OVP/UVL levels and selects the
Address
5.2.1
5.3.1
5.4.1
7.2.2
2 VOLTAGE indicator Green LED, lights for constant-Voltage mode operation.
3 VOLTAGE display 4 digit, 7-segment LED display. Normally displays the out-
put voltage. When the PREV button is pressed, the display
indicates the programmed setting of the output voltage.
When the OVP/UVL button is pressed, the Voltage display
indicates the OVP/UVL setting.
4 CURRENT display
4 digit, 7 segment LED display. Normally displays the out-
put current. When the PREV button is pressed, the display
indicates the programmed setting of output current.
5 CURRENT indicator Green LED, lights for Constant-Current mode operation
6 CURRENT control
High resolution rotary encoder for adjusting the Output
Current. Also selects the Baud-Rate of the communication
port. 5.2.2
7.2.4
7 OUT button
Main function: Output ON/OFF control. Press OUT to set
the output On or Off. Press to reset and turn On the output
after OVP or FOLD alarm events have occurred.
Auxiliary
function: Selects between “Safe-Start” and “Auto-Restart”
modes. Press and hold OUT button to toggle between
“Safe-Start” and “Auto-Restart”. The VOLT display will cy-
cle between “SAF” and “AUT”. Releasing the OUT button
while one of the modes is displayed, selects that mode.
5.6
5.11
8 OUT indicator Green LED, lights when the DC output is enabled.
9 REM/LOC button
Main function : Go to local. Press REM/LOC to put the unit
into Local (REM/LOC button is disabled at Local Lockout
mode).
Auxiliary function: Address and Baud Rate setting. Press
and hold REM/LOC for 3 sec. to set the Address with the
VOLTAGE encoder and the Baud Rate with the CURRENT
encoder.
7.2.5
7.2.2
7.2.4
10 REM/LOC indicator Green LED, lights when the unit is in Remote mode.
11 FOLD button
Foldback protection control.
-Press FOLD to set Foldback protection to On.
-To release Foldback alarm even, press OUT to enable the
output and re-arm the protection.
-Press FOLD again to cancel the Foldback protection.
5.5
12 FOLD indicator Green LED, lights when Foldback protection is On.