83-530-000 Rev. G
7
1.2.3
Control via the serial communication port
The following parameters can be programmed via the serial communication port:
1. Output voltage setting.
2. Output current setting.
3. Output voltage measurement.
4. Output On/Off control.
5. Output current measurement.
6. Foldback protection setting
7. Over-voltage protection setting and readback.
8. Under-Voltage limit setting and readback.
9. Power-supply start up mode (last setting or safe mode).
1.2.4
Analog voltage programming and monitoring
Analog inputs and outputs are provided at the rear panel for analog control of the power supply. The
output voltage and the current limit can be programmed by analog voltage or by resistor, and can be
monitored by analog voltage. The power supply output can be remotely set to On or Off and analog
signals monitor the proper operation of the power supply and the mode of operation (CV/CC).
1.2.5
Parallel operation
Genesys
TM
power supplies of the same output voltage and current rating can be paralleled in master-
slave configuration with automatic current sharing to increase power available.
1.2.6
Output connections
Output connections are made to rear panel via bus-bars up to 300V. For greater than 300V
o
via stud
terminals. Either the positive or negative terminal may be grounded or the output may be floated. Con-
tact factory for assistance with higher float voltage applications. Local or remote sense may be used. In
remote sense, the voltage drop on the load wires should be minimized. Refer to the specifications for
the maximum voltage drop value.
1.2.7
Cooling and mechanical construction
The Genesys
TM
series is cooled by internal fans. At the installation, care must be taken to allow free
airflow into the power supply via the front panel and out of the power supply via the rear panel.
Observe all torque guidelines within this manual. Over torqueing may damage
unit or accessories. Such damage is not covered under manufacturer’s warranty.
CAUTION
Summary of Contents for GENESYS 10KW
Page 2: ......
Page 3: ......
Page 31: ...83 530 000 Rev G 28 Fig 4 2 Rear panel connections and controls...
