TDK-Lambda GENESYS 10KW, Technical Manual

Page: 64 / 74

83-530-000 Rev. G
61
The power supply can accept values higher 5% than the table values, however it is not recommended to
program the power supply over the rated values.
Table 7-5: OVP programming range Table 7-6: UVL programming range
Model
Rated Output Voltage (V)
Minimum
(V)
Maximum
(V)
Model
Rated Output Voltage (V)
Minimum
(V)
Maximum
(V)
7.5-1000 0.75 8.25 7.5-1000 0 7.125
10-1000 1 11 10-1000 0 9.5
12.5-800 1.25 13.75 12.5-800 0 11.875
20-500 2 22 20-500 0 19
25-400 2.5 27.5 25-400 0 23.75
30-333 3 33 30-333 0 28.5
40-250 4 44 40-250 0 38
50-200 5 55 50-200 0 47.5
60-167 6 66 60-167 0 57
80-125 8 88 80-125 0 76
100-100 10 110 100-100 0 95
125-80 12.5 137.5 125-80 0 118.75
150-66 15 165 150-66 0 142.5
200-50 20 220 200-50 0 190
250-40 25 275 250-40 0 237.5
300-33 30 330 300-33 0 285
400-25 40 440 400-25 0 380
500-20 50 550 500-20 0 475
600-17 60 660 600-17 0 570
7.9.6 Status Control Commands
Refer to Section 7-10 for definition of the registers.
# Command Description
1 STT? Reads the complete power supply status.
Returns ASCII characters representing the following data, separated by commas:
MV<actual (measured) voltage>
PC<programmed (set) current>
PV<programmed (set) voltage> SR<status register, 2-digit hex>
MC<actual (measured) current> FR<fault register, 2-digit hex>
Example response: MV(45.201),PV(45), MC(4.3257), PC(10), SR(30), FR(00)
2 FLT? Reads Fault Conditional Register. Returns 2-digit hex.
3 FENA Set Fault Enable Register using 2-digit hex.
4 FENA? Reads Fault Enable Register. Returns 2-digit hex.
5 FEVE? Reads Fault Event Register. Returns 2-digit hex. Clears bits of Fault Event Register.
6 STAT? Reads Status Conditional Register. Returns 2-digit hex.
7 SENA Sets Status Enable Register using 2-digit hex.
8 SENA? Reads Status Enable Register. Returns 2-digit hex.
9 SEVE? Reads Status Event register. Returns 2-digit hex. Clears bits of Status Event register.