9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
3.67
5. Verify that the timing marks
q
are in alignment as
shown below.
6. Carefully install the camshaft carrier onto the
camshafts.
7. Install the four bolts that retain the camshaft carrier.
Tighten the bolts evenly until snug. Do not torque at
this time.
8. Verify cam timing is correct and the piston is a TDC.
9. If timing marks are not aligned:
• Remove the cam carrier bolt and cam carrier.
• Correct the camshaft timing as needed.
• Reinstall the cam carrier.
• Re-check cam timing.
10. If needed, install the camshaft carrier and bolts.
11. Torque the camshaft carrier bolts in sequence to
specification.
TORQUE
Camshaft Carrier Bolts:
7 ft-lbs (10 Nm)
12. Install
camshaft
sprocket
bolt
and
torque
to
specification.
TORQUE
Camshaft sprocket Bolt
44 ft-lb (60 Nm)
NOTE
Ensure exhaust decompression mechanism still moves
freely and returns by spring force after sprocket has
been installed.
13. Insure the
new
sealing washer
q
is in place.
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...
