9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
6.11
4. Install the Clutch Center Distance Tool (PU-50658)
onto the crankshaft and transmission input shaft to
properly position the clutch center distance. The
pictures below show the tool (PU-50658) properly
installed.
5. In sequence, torque the eight engine coupler bracket
fasteners to specification.
TORQUE
Engine to Trans Coupler Fasteners
In Sequence:55 ft-lb (75 Nm)
6. Remove the clutch center distance tool.
7. Remove the spacer or support between the vehicle
frame and engine.
8. Install and properly route the gear position switch
connector
i
, speed sensor connector
o
, crankshaft
position sensor connector, shift bracket bolts
a
, shift
bracket
s
, shift cable clevis pin and washer
d
onto
the transmission.
9. Torque
the
two
shift
cable
bracket
bolts
to
specification.
TORQUE
Shift Cable Bracket Bolts:
37 ft-lbs (50 Nm)
10. Install three wire ties to retain wire harness to
transmission and mounts.
11. Install and properly route the vent hose.
12. Install inner clutch cover, outlet duct, drive clutch,
driven clutch, belt and outer clutch cover (see
Chapter 6).
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...
