Taylor-Dunn G0-010-00, Service And Replacement Parts Manual

Page: 312 / 362

9.24
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
REAR BRAKE DISC
DISC RUNOUT
1. Mount a dial indicator and measure disc runout.
Slowly rotate the disc and read total runout on the
dial indicator. Replace the disc if runout exceeds
specification.
MEASUREMENT
Brake Disc Runout
Service Limit .010” (.254 mm)
BRAKE DISC INSPECTION
1. Check the surface condition of the brake discs.
2. Measure the thickness of the front and rear brake
discs.
3. The disc (s) should be replaced if thickness is less
than the specified service limit
REF PART SERVICE LIMIT
q Front Disc See the
Specifications at the
beginning of the
Brakes Chapter
w Rear Disc See the
Specifications at the
beginning of the
Brakes Chapter
WARNING
Do not apply WD-40 or any petroleum product to brake
discs. These types of products are flammable and may
also reduce the friction between the brake pad and
caliper.
DISC REMOVAL / REPLACEMENT
1. Remove brake caliper (see “Brake Caliper Service”).
2. Remove cotter pin
q
, castle nut
w
and washers
e
.
3. Remove the wheel hub assembly from the vehicle
and remove the four bolts
r
retaining the disc to the
hub.
4. Clean the wheel hub mating surface and install new
disc on wheel hub.
5. Apply Loctite® 272 to new bolts, install and torque to
specification.
BRAKE SYSTEM