Taylor-Dunn G0-010-00, Service And Replacement Parts Manual

Page: 97 / 362

3
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
3.37
REF. DESCRIPTION NOTES
q Cylinder Apply ENGINE OIL to bottom 50 mm of cylinder bore and to piston
rings before assembly.
w Cylinder Base Gasket Ensure tab is visible to verify assembly.
e Plug Torque: 11 ft-lbs (16 Nm)
r O-ring Ensure O-ring seals are seated in C’bores before assembly.
t Screw Torque: 20 ft-lbs (28 Nm)
y Straight Filter Adapter Torque: 20 ft-lbs (28 Nm)
u Oil Filter Lubricate seal with engine oil prior to filter installation.
i Gear Sprocket to be installed so that “OUT” is visible.
o Screw Torque: (12 Nm)
Replace if loosened or removed.
a Gear Sprocket to be installed so that “OUT” is visible.
s Screw Torque: 106 in-lbs (12 Nm)
d Oil Pump Cover Apply ENGINE OIL to bore of oil pump cover prior to assembly.
f Drain Plug Torque: 11 ft-lbs (16 Nm)
g Gerotor Inner Gerotor Slot must be visible after assembly
h Gerotor Outer Gerotor dots must not be visible after assembly.
j Piston Assembly Apply ENGINE OIL to bottom 50 mm of cylinder bore and to piston
rings before assembly.
ENGINE / COOLING SYSTEM