3.12
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
6. Install the Clutch Center Distance Tool (PU-50658-A)
onto the crankshaft and transmission input shaft. The
pictures below show a properly installed tool (PU-
50658).
NOTE
Images for Reference only. The tool shown should only
be used to check center to center distance.
The location the tool rests on the shafts may vary.
The TAYLOR-DUNN G-100 uses the holes marked
with a 3 on the Clutch Center Distance Tool (PU-
50658-A).
7. In sequence, torque the eight engine coupler bracket
fasteners to specification.
8. Torque fasteners in order according to image.
TORQUE
Rear Engine Coupler Fastener (In Sequence):
In Sequence:55 ft-lb (75 Nm)
9. In a criss-cross pattern, torque the four front engine
mount fasteners to specification.
TORQUE
Front Engine Mount Fasteners:
40 ft-lbs (54 Nm)
10. Torque the two front center isolator bolts
r
to
specification.
TORQUE
Isolator Center Bolt:
40 ft-lbs (54 Nm)
11. Remove the lifting straps and overhead or portable
engine hoist and remove the support previously
installed under the transmission case during the
engine removal process.
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...