9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
11.17
IGNITION COIL
OPERATION OVERVIEW
The ignition coil
q
is used to provide high voltage to fire
the spark plug. When the ignition key is on, DC voltage is
present in primary side of the ignition coil windings.
During engine rotation, an AC pulse is created within the
crankshaft position sensor for each passing tooth on the
flywheel. The two-tooth gap creates an “interrupt” input
signal, corresponding to specific crankshaft position. This
signal serves as a reference for the control of ignition
timing. The ECU then calculates the time interval
between the consecutive pulses, and determines when
to trigger the voltage spike that induces the voltage from
the primary to the secondary coil windings to fire the
spark plug.
IGNITION COIL TESTS
The ignition coil can be tested by using an Ohm meter.
Use the following specification table and illustrations to
test the ignition coil.
Ignition Coil Resistance Readings
TEST
PIN CONNECTION
RESISTANCE
Primary
Between Battery (+) &
Coil (-)
0.5 Ω ± 10%
Primary
Test
Between Coil (-) and
(+) at the Coil
Connection
0.5 Ω
Secondary
Test
Between High Tension
Lead Caps
7.0 k Ω ± 5%
PRIMARY TEST
SECONDARY TESTS
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...
