9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
3.55
5. Record measurements taken in Step 4. If cylinder is
tapered, or out of round beyond .001, cylinder must
be re-bored oversize, or replaced.
Cylinder Taper Limit:
.001″ Max. (0.025 mm)
Cylinder Out of Round Limit:
.001″ Max. (.025 mm)
Standard Bore Size:
3.6614 +/- 0.0003″ (93.0 +/- 0.008 mm)
PISTON REMOVAL
1. Note piston directional indicator “EX” positioned
toward the exhaust side of engine.
2. Remove piston circlip and push piston pin out of
piston. If necessary, heat the crown of the piston
slightly
with a heat gun.
CAUTION
Do not apply heat to the piston rings, they may lose
radial tension.
3. Remove top ring.
NOTICE
*Using a piston ring pliers
: Carefully expand ring and
lift it off the piston.
CAUTION
Do not expand the ring more than the amount
necessary to remove it from the piston.
*By hand:
Using both thumbs, spread the ring open
and push up on the opposite side.
4. Repeat procedure for second ring.
5. Remove oil control ring top rail first, then bottom rail.
6. Remove oil control ring expander.
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...
