Taylor-Dunn G0-010-00, Service And Replacement Parts Manual

Page: 217 / 362

5
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
5.21
13. Thoroughly clean bushing bore
14. Apply Loctite™ 609 evenly to bushing bore inside
moveable sheave.
15. Set bushing in place on sheave.
16. Insert installation puller tool (Item A/B) with “A” side
down, into center of bushing.
17. With towers pointing upward, slide sheave, bushing
and tool onto puller rod.
18. Install nut on puller rod and hand tighten. Turn barrel
to apply additional tension if needed.
19. Turn sheave counterclockwise, making sure bushing
is drawn straight into bore. Continue until bushing is
seated.
20. Remove nut from puller rod and set aside.
21. Remove sheave from puller.
22. Remove installation tool.
Cover Bushing Removal
23. Install main adapter (Item 8) on puller.
24. Install adapter reducer (Item 9).
25. From outside of clutch cover, insert removal tool
(Item 3) into cover bushing.
26. With inside of cover toward vise, slide cover onto
puller.
27. Install nut onto puller rod and hand tighten. Turn
puller barrel to increase tension as needed.
28. Turn clutch cover counterclockwise on puller rod until
bushing is removed and cover comes free.
29. Remove nut from puller rod and set aside.
30. Remove bushing and bushing removal tool from
puller. Discard bushing.
Cover Bushing Installation
31. Apply Loctite™ 609 evenly to bushing bore in cover.
32. Working from inside of cover, insert new bushing and
bushing installation tool into center of clutch cover.
33. With main adapter on puller, insert cover onto puller
rod, placing outside of cover toward vise.
34. Install nut on rod and hand tighten. Turn puller barrel
to apply more tension if needed.
35. Turn clutch cover counterclockwise on puller rod until
bushing is seated.
36. Remove nut from puller rod. Take installation tool
and clutch cover off rod.
CVT SYSTEM