Taylor-Dunn G0-010-00, Service And Replacement Parts Manual

Page: 297 / 362

9
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
9.9
BRAKE SERVICE PROCEDURES
BRAKE BLEEDING / FLUID CHANGE
NOTE
When bleeding the brakes or replacing the fluid always
start with the furthest caliper from the master cylinder.
CAUTION
Always wear safety glasses. Brake fluid can cause
blindness.
CAUTION
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.
1. Locate master cylinder reservoir under the hood.
Clean reservoir cover thoroughly.
2. Remove cover from reservoir.
3. If changing fluid, remove old fluid from reservoir with
a Mity Vac™ pump or similar tool.
Mity Vac™ (PN 2870975)
4. Add brake fluid to the indicated MAX level
q
of
reservoir.
DOT 4 Brake Fluid
(P/N 2872189)
5. Begin bleeding procedure with caliper furthest from
master cylinder.
6. Install a box-end wrench on caliper bleeder screw
w
.
7. Attach a tight-fitting, clear hose to the bleeder fitting.
8. Place a small amount of fresh brake fluid into a small,
clear container and place the other end of bleeder
hose into the container.
9. Have an assistant slowly pump the brake pedal until
pressure builds and then hold.
10. Quickly open and close the bleed screw while holding
pressure on the brake pedal.
NOTE
Do not release brake pedal before bleeder screw is
tight or air may be drawn into master cylinder.
11. Release brake pedal pressure. Check level of fluid in
reservoir and add if necessary (Figure 1-6).
12. Repeat Steps 9, 10, and 11 until brake pedal is firm
and no air can be seen moving through the clear
hose. Add fluid as necessary to maintain level in
reservoir.
Master Cylinder Fluid Level
Between the MIN and MAX line
CAUTION
Maintain at least 1/2"(1.27 cm) of brake fluid in the
reservoir to prevent air from entering the master
cylinder.
13. Tighten bleeder screw and remove bleeder hose.
Torque bleeder screw to specification.
TORQUE
Bleeder Screw:
47 in-lbs (5.3 Nm)
BRAKE SYSTEM