Operating the Equipment Locally — Setup Menu: Video Menu
Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder
Page 4-31
ST.RE.E10137.3
Action On PID Error Option
This option enables the Action On PID Error to be set.
Table 4.17: Action on PID Error Options
Selected Option
Description
Raise Alarm
An error message is displayed if a PID error is found.
Auto Correct
If a PID error is found it is automatically corrected.
SNMP Control Option
This option enables the SNMP Control to be set.
Table 4.18: SNMP Control Options
Selected Option
Description
Wait for Initialisation
No SNMP reply during initialisation.
From Power On
Reply as modules start to appear.
Display Contrast Option
NOTE…
When this softkey is pressed, the display changes immediately.
This option allows the contrast ratio of the LCD display to be set. The
contrast range is: Very Light, Light, Medium, Dark, Very Dark. As the key
is pressed the display changes.
If the background is set to very dark or very light, the text may not be
visible. In this instance, view the display at an acute angle, this should
enable the text to be seen enough to change the contrast.
No. Services Option
This option is only available if the syntax is set to DVB. It defines how
many services (up to eight) the Encoder can generate in the output
transport stream. If the number of services is greater than one then there
is an additional menu
Mbd Services
which allows the additional services to
be defined (see Section 4.5.10) In ATSC only one motherboard service is
possible.
Mbd. Service PIDs Option
This option is only available if the number of services is greater than one.
The motherboard service PIDs option defines whether the PIDs assigned to
a service are unique, or can be duplicated between services. If the option
is set to unique PIDs, then an elementary stream such as video can only
be assigned to one service. Alternatively, if duplicate PIDs are allowed,
then an elementary stream can be shared by services, but this does mean
that both services must have the same scrambling setting.
Reset On Download Option (Status Only)
The option is status only. The Encoder automatically reboots following a
download, keeping the current configuration.
