Operating the Equipment Locally Data Menu
Reference Guide: Voyager E5784 and E5788 HD DSNG Encoder
Page 4-95
ST.RE.E10137.3
NOTES…
1.
This option is only available in Tandberg mode.
2.
This can result in wasted bandwidth due to low packet occupancy. Also results in a higher packet
rate which may cause some receivers to overflow.
Delay Option
This option enables the Delay to be set. The option cannot be changed.
SNMP oid index Option
All option modules have the same SNMP oid (object identifier) with the
exception of one byte which identifies which slot the module is in. An MEM
expects the data module to be in slot two or three in the previous version
of the Encoder. Therefore, slots one and two in this Encoder have been
allocated to correspond directly to slots two and three in the previous
Encoder.
In this Encoder the data module can be allocated to slot one, making it
inaccessible to an MEM. This variable allows the on-board data module to
be apparently moved around - to a slot in which it may be referenced by
the MEM.
Table 4.106: SNMP oid index Options
Selected Option
Description
Min:
1
Max:
7
Oid index
O/P Bit-rate Option
This option is for status only and indicates the output bit-rate.
4.8.3
Data B - RS422 Menu
Encoding Option
This option enables the RS-422 synchronous data channel to be switched
On or Off.
Bit-rate Option
This option enables the bit-rate of the RS-422 synchronous data channel to
be set.
Table 4.107: Bit-rate Options
Selected Option
Description
Settings cycle from 56 to 1792 in steps of 56 then from 64 to
2048 in steps of 64, then back to 56
RS-422 synchronous data
channel bit-rate.