Suzuki Intruder VZ1500, Service Manual

Page: 494 / 580

5B-8 Manual Transmission:
5) Remove the left driveshaft bearing (4) with the
special tool.
Special tool
(D): 09913–70210 (Bearing installer set)
6) Remove the bearing retainers (5).
7) Remove the right gearshift cam bearing (6) by hand.
8) Remove the right countershaft bearing (7) and right
driveshaft bearing (8) with the special tool.
Special tool
: 09921–20240 (Bearing remover set)
Installation
Install the each bearing in the reverse order of removal.
Pay attention to the following points:
CAUTION
!
The removed bearing must be replaced with a
new one. (Except for right gearshift cam
bearing)
• Install the right driveshaft bearings (1) and
countershaft bearing (2) with the special tool and
install the right gearshift cam bearing (3) by hand.
CAUTION
!
Use the special tool suitable size for each
bearing to prevent damage.
NOTE
• The sealed side “A” of right driveshaft
bearing (1) faces outside of crankcase.
• The stamped mark side of the bearing
faces inside of crankcase.
Special tool
: 09913–70210 (Bearing installer set)
• Apply thread lock to the screws, and install the
retainers (4) by tightening them.
: Thread lock cement 99000–32050
(THREAD LOCK CEMENT 1342 or equivalent)
(D)
4
I940H1520030-01
5
5
I940H1520031-01
6
7
8
I940H1520032-01
“A”
1
I940H1520033-01
1
2
3
I940H1520034-01
4
4
I940H1520035-01