4C-8 Rear Brakes:
Brake Disc Runout
1) Dismount the rear brake caliper. Refer to “Rear
Brake Caliper Removal and Installation (Page 4C-
3)”.
2) Measure the runout using the dial gauge.
Replace the disc if the runout exceeds the service
limit.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
: 09900–20701 (Magnetic stand)
Brake disc runout
Service limit: 0.30 mm (0.012 in)
3) Remount the rear brake caliper. Refer to “Rear
Brake Caliper Removal and Installation (Page 4C-
3)”.
Specifications
Service Data
B940H24307001
Brake
Unit: mm (in)
Tightening Torque Specifications
B940H24307002
NOTE
The specified tightening torque is described in the following.
“Rear Brake Components (Page 4C-1)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-8)”.
(A)
I649G1430028-03
Item
Standard
Limit
Rear brake pedal height
60 – 70 (2.4 – 2.8)
—
Brake disc thickness
Rear
6.6 – 7.0 (0.260 – 0.276)
6.3 (0.25)
Brake disc runout
Front & Rear
—
0.30 (0.012)
Brake caliper cylinder bore
Rear
30.230 – 30.306 (1.1902 – 1.1931)
—
Brake caliper piston diam.
Rear
30.150 – 30.200 (1.1870 – 1.1890)
—
Brake fluid type
DOT 4
—
Fastening part
Tightening torque
Note
N
⋅
m
kgf-m
lbf-ft
Rear brake caliper mounting bolt
54
5.4
39.0
Brake hose union bolt
23
2.3
16.5
Brake disc bolt
23
2.3
16.5
Summary of Contents for Intruder VZ1500
