Suzuki Intruder VZ1500, Service Manual

Page: 35 / 580

Maintenance and Lubrication: 0B-6
12) Inspect the #2 (Front) cylinder tappet clearance as
the same manner of #1 (Rear) cylinder and adjust
the clearance if necessary.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09917–10410 (Valve adjuster driver)
Tightening torque
Valve clearance adjuster lock-nut: 15 N·m (1.5
kgf-m, 11.0 lbf-ft)
13) After inspect and adjust the clearance, apply grease
to the valve timing inspection cap O-rings and install
the inspection caps (6).
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Use a new O-rings to prevent oil leakage.
14) Tighten the valve timing inspection cap bolts to the
specified torque.
Tightening torque
Valve timing inspection cap bolt (a): 10 N·m (1.0
kgf-m, 7.0 lbf-ft)
15) Tighten the generator cover cap and valve timing
inspection plug to the specified torque.
Tightening torque
Generator cover cap (b): 11 N·m (1.1 kgf-m, 8.0
lbf-ft)
Valve timing inspection plug (c): 23 N·m (2.3
kgf-m, 16.5 lbf-ft)
Spark Plug Replacement
B940H20206005
Replace spark plug
Every 12 000 km (7 500 miles, 24 months)
Refer to “Spark Plug Cap and Spark Plug Removal and
Installation in Section 1H (Page 1H-4)”.
(B)
(A)
I940H1020016-01
6
I940H1020017-01
(a)
(a)
I940H1020068-01
(b)
(c)
I940H1020018-03