Ignition System: 1H-9
7) If the peak voltage is within the specification, check
the continuity between the CKP sensor coupler and
ECM coupler.
CAUTION
!
Normally, use the needle pointed probe to the
backside of the lead wire coupler to prevent
the terminal bend and terminal alignment.
8) After measuring the CKP sensor peak voltage,
connect the CKP sensor coupler.
CKP Sensor Resistance
1) Disconnect the CKP sensor coupler (1).
2) Measure the resistance between the lead wires and
ground. If the resistance is not within the standard
range, replace the CKP sensor with a new one.
Refer to “CKP Sensor Removal and Installation
(Page 1H-9)”.
Tester knob indication
Resistance (
Ω
)
CKP sensor resistance
160 – 270
Ω
(Bl – G)
∞
Ω
(Bl – Ground)
3) After measuring the CKP sensor resistance, connect
the CKP sensor coupler.
CKP Sensor Removal and Installation
B940H21806007
Refer to “Generator Removal and Installation in Section
1J (Page 1J-5)”.
Engine Stop Switch Inspection
B940H21806008
Inspect the engine stop switch in the following
procedures:
1) Turn the ignition switch OFF.
2) Remove the headlight. Refer to “Headlight Removal
and Installation in Section 9B (Page 9B-2)”.
3) Disconnect the right handlebar switch coupler (1).
4) Inspect the engine stop switch for continuity with a
tester.
If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
“Handlebars Removal and Installation in Section 6B
(Page 6B-1)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity (
)
5) After finishing the engine stop switch inspection,
reinstall the removed parts.
Ignition Switch Inspection
B940H21806009
Refer to “Ignition Switch Inspection in Section 9C
(Page 9C-9)”.
2. CKP sensor coupler
3. CKP sensor
1
I940H1180013-03
3
2
I718H1180008-02
1
I940H1180014-03
O/B
O/W
Color
Position
OFF
RUN
(
)
(
)
I822H1180023-01
Summary of Contents for Intruder VZ1500
