2D-16 Wheels and Tires:
2) Install the tire onto the wheel.
CAUTION
!
For installation procedure of tire onto the
wheel, follow the instructions given by the
tire changer manufacturer.
NOTE
• When installing the tire, the arrow “A” on
the side wall should point to the direction
of wheel rotation.
• Align the chalk mark put on the tire at the
time of removal with the valve position.
3) Bounce the tire several times while rotating. This
makes the tire bead expand outward to contact the
wheel, thereby facilitating air inflation.
4) Install the valve core and inflate the tire.
WARNING
!
• Do not inflate the tire to more than 400 kPa
(4.0 kgf/cm
2
, 57 psi). If inflated beyond this
limit, the tire can burst and possibly cause
injury. Do not stand directly over the tire
while inflating.
• In the case of preset pressure air inflator,
pay special care for the set pressure
adjustment.
5) In this condition, check the “rim line” “B” cast on the
tire side walls. The line must be equidistant from the
wheel rim all around.
6) If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly
seated. If this is the case, deflate the tire completely
and unseat the bead for both sides. Coat the bead
with lubricant and fit the tire again.
7) When the bead has been fitted properly, adjust the
pressure to specification.
8) As necessary, adjust the tire balance. Refer to
“Wheel Balance Check and Adjustment (Page 2D-
18)”.
Cold inflation tire pressure
9) Install the wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation (Page 2D-3)”
and “Rear Wheel Assembly Removal and Installation
(Page 2D-10)”.
Wheel / Tire / Air Valve Inspection and Cleaning
B940H22406012
Refer to “Tire Removal and Installation (Page 2D-15)”.
Wheel
Wipe the wheel clean and check for the following points:
• Distortion and crack
• Any flaws and scratches at the bead seating area.
• Wheel rim runout. Refer to “Front Wheel Related
Parts Inspection (Page 2D-5)” and “Rear Wheel
Related Parts Inspection (Page 2D-12)”.
“A”
I649G1240039-02
“B”
I649G1240040-02
Front
Rear
Solo
riding
250 kPa
(2.50 kgf/cm
2
, 36 psi)
250 kPa
(2.50 kgf/cm
2
, 36 psi)
Dual
riding
250 kPa
(2.50 kgf/cm
2
, 36 psi)
290 kPa
(2.90 kgf/cm
2
, 42 psi)
I649G1240041-02
Summary of Contents for Intruder VZ1500
