Fuel System: 1G-19
Assembly
Assembly is in the reverse order of disassembly with
special attention to the following steps.
High pressure fuel pump
Connect the pump lead wire connector, then install the
filter (1), bush (2), joint (3), bush (4) and fuel pump (5).
NOTE
Apply fuel to the grommet, joint and bush
before installing.
Float / Float pin
• Install the valve seat (1), then tighten screw (2)
securely.
• Install the needle valve (3), float (4) and float pin (5),
then tighten screw (6) securely.
NOTE
After assembling, check for smooth and free
float movement.
Checking float height
Measure the float height.
Special tool
: 09900–20101 (Vernier calipers (150 mm))
Float height “a”
Standard: 47 ± 3.0 mm
NOTE
Make sure that the float weight is not applied
to the needle valve.
1
2
3
5
4
IAJ611170033-01
5
IAJ611170034-01
2
3
1
5
6
4
IAJ611170035-01
IAJ611170036-01
“a”
IAJ611170037-01
Summary of Contents for GF60A
