Suzuki GF60A, Service Manual

Page: 314 / 336

3A-20 Right Hand Rotation Unit:
• Apply water resistant grease to the bearing housing
O-ring (6).
NOTE
Before installing the propeller shaft / bearing
housing assembly, bring shift cam to the
forward position by moving shift rod up or
down.
• Using special tools, install the propeller shaft and
housing assembly in the gearcase.
Special tool
(A): 09922–59410 (Propeller shaft housing
installer)
(B): 09922–59420 (Housing installer handle)
• When the housing is fully seated, tighten both
retaining bolts to the specified torque.
Tightening torque
Bearing housing bolt (a): 23 N·m (2.3 kgf-m, 16.6
lbf-ft)
Rechecking Driveshaft Thrust Play
Recheck the driveshaft thrust play. This should not be
less than previously checked. If less, reduce the number
/ thickness of the reverse gear back-up shims. Refer to
“Lower Unit Gears - Shimming and Adjustment” (Page
3A-22).
Special tool
(A): 09951–09530 (Gear adjusting gauge)
Checking Propeller Shaft Thrust Play
Check propeller shaft thrust play. Refer to “Lower Unit
Gears - Shimming and Adjustment” (Page 3A-22).
Leakage Check
Check for leakage of oil seal and O-ring when applying
specified pressure inside of the gearcase.
1) Temporarily fasten the driveshaft bearing housing to
gearcase using two bolts and nuts (placed through
the two diagonally opposite gearcase mounting
holes).
6
IAJ611310079-01
(A)
(B)
IAJ611310080-01
(a)
IAJ611310081-01
(A)
IAJ611310082-02
(A)
IAJ611310083-01
IAJ611310084-01