Power Trim and Tilt: 2B-14
6) Remove two bolts and anode (4).
7) Remove the two bolts (5) securing PTT cylinder
lower shaft to STBD / PORT clamp brackets.
8) Remove two PORT motor mounting bolts (6).
Using flat screw driver, drive locking edge of lock
washer (7) to clamp bracket side.
Remove the clamp bracket shaft nut (8).
9) Slide PORT clamp bracket (9) off clamp bracket
shaft, then remove PTT unit (10) and cylinder lower
shaft.
Installation
Installation is reverse order of removal with special
attention to the following steps.
• Lower tilt rod to full down position.
• Apply water resistant grease to the tilt cylinder lower
shaft and lower shaft bushing.
Install the lower shaft bushing (1) and cylinder lower
shaft (2) to PTT unit. Install the spacer (3) to cylinder
lower shaft.
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
• Place PTT unit in position, then install clamp bracket.
• Tighten clamp bracket shaft nut (4) to specified
torque.
Tightening torque
Clamp bracket shaft nut (a): 43 N·m (4.3 kgf-m,
31.0 lbf-ft)
4
IAJ611220023-01
5
IAJ611220025-01
5
IAJ611220026-01
6
7
8
IAJ611220027-01
9
10
IAJ611220028-01
1
2
3
IAJ611220029-01
IAJ611220030-01
Summary of Contents for GF60A
