Suzuki GF60A, Service Manual

Page: 301 / 336

Right Hand Rotation Unit: 3A-7
Installation
1) Place the under panel gasket (1) and under panel (2)
into position.
2) Insert the key (3) in the driveshaft and slide the
impeller (4) onto driveshaft, ensuring that key and
keyway is aligned.
NOTE
Before installing pump inner sleeve, apply
SUZUKI Bond 1207B lightly between inner
sleeve and pump case mating surfaces.
: Sealant 99000–31140 (SUZUKI Bond
1207B (100 g))
3) Install inner sleeve (5) into the pump case (6),
ensuring that projection of inner sleeve and groove
of pump case are aligned.
4) Place the seal ring (7) into groove of the pump case
(6).
CAUTION
Do not reuse seal ring once removed. Always
use new ring.
NOTE
Before installing water pump case assembly,
apply water resistant grease lightly on pump
case inner sleeve and under panel for initial
lubrication.
5) Install the pump case assembly (8) while rotating
driveshaft clockwise to flex the impeller vanes in the
correct direction.
Securely tighten the four pump case nuts (9) to the
specified torque.
Tightening torque
Water pump case nut (a): 8 N·m (0.8 kgf-m, 6.0
lbf-ft)
6) Install the Lower Unit. Refer to “Lower Unit Removal
and Installation” (Page 3A-5).
1
2
3
4
IAJ611310013-01
5
6
IAJ611310014-01
6
7
IAJ611310015-02
IAJ611310016-01
(a)
9
8
IAJ611310017-02