Suzuki GF60A, Service Manual

Page: 262 / 336

2A-24 Housing and Bracket:
18) Pull STBD clamp bracket (25) outward to remove
clamp bracket and bracket shaft (26) from swivel
bracket (27). Remove washer (28) and bushing (29)
from each side of swivel bracket.
Clamp / Swivel / Steering Brackets Assembly
ZAJ6112106012
Assembly is reverse order of disassembly with special
attention to the following steps.
Clamp Bracket / Swivel Bracket
NOTE
Before installing clamp bracket to swivel
bracket, apply grease to clamp bracket shaft
and bushings.
: Grease 99000–25161 (SUZUKI Water Resistant
Grease (250 g))
• Insert PORT and STBD bushings (2) into the swivel
bracket (1).
• Assemble STBD clamp bracket (3), washer (4), clamp
bracket shaft (5) and swivel bracket (1).
• Apply Thread Lock 1342 to threads of shaft bolt (5)
before threading it to STBD clamp bracket.
Install the shaft bolt (5), then tighten it securely.
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
• Install PTT unit and lower shaft assembly (6). Refer to
“Power Trim and Tilt Unit Removal and Installation” in
Section 2B (Page 2B-13).
• Install washer (7), PORT clamp bracket (8), lock
washer (9) and clamp bracket shaft nut (10).
25
28
29
26
29 28
27
IAJ611210090-01
2
2
1
IAJ611210091-01
1
3
5
4
IAJ611210092-01
5
IAJ611210093-01
6
IAJ611210094-01
7
8
9
10
IAJ611210095-01