Suzuki GF60A, Service Manual

Page: 243 / 336

Housing and Bracket: 2A-5
2) Apply the water resistant grease to the bushes (2),
then install the bushes (2) to tiller handle (3).
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
3) Place the two spring washers (4), three washers (5)
and washer (6) into position.
Insert handle pivot bolt (7).
Coat the pivot bolt threads with thread lock and
tighten pivot bolt to specified torque.
NOTE
Install the spring washers (4) with direction
as shown in figure.
: Thread lock cement 99000–32050
(SUZUKI Thread Lock 1342 (50 g))
Tightening torque
Tiller handle pivot bolt (a): 25 N·m (2.5 kgf-m,
18.0 lbf-ft)
4) Install washer (5), nut (8) and tighten nut to specified
torque.
Tightening torque
Handle pivot nut (b): 45 N·m (4.5 kgf-m, 32.0 lbf-
ft)
5) Install the tiller handle and handle bracket assembly
(9) to steering bracket extension (10), then tighten
bolts (11), pre-coated with thread lock, to specified
torque.
: Thread lock cement 99000–32050
(SUZUKI Thread Lock 1342 (50 g))
Tightening torque
Tiller handle mounting bolt (c): 50 N·m (5.0 kgf-
m, 36.0 lbf-ft)
Throttle/Shift cable installation
1) Insert the shift cable (1), throttle cable (2) and handle
wire harness (3) through the rigging port grommet
(4) as shown in figure.
2
2
3
IAJ011210009-01
5
6
8
4
(a)
7
5 5
IAJ011210010-02
5 5 4 7
IAJ011210035-02
5
(b)
8
IAJ011210036-02
9
10
(c)
11
IAJ611210017-01
1
2
3
4
IAJ611210018-01