2A-18 Housing and Bracket:
Upper Mount Nut and Lower Mount Nut
• Install the engine holder/ oil pan/ drive shaft housing
assembly to steering bracket.
• Install washer (2) and upper mount nut (1), then
tighten two nuts, pre-coated with thread lock, to
specified torque.
Tightening torque
Upper mount nut (a): 60 N·m (6.0 kgf-m, 43.4 lbf-
ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
• Install washer (4) and lower mount nut (3), then
tighten two nuts, pre-coated with thread lock, to
specified torque.
Tightening torque
Lower mount nut (b): 60 N·m (6.0 kgf-m, 43.4 lbf-
ft)
: Thread lock cement 99000–32050 (SUZUKI
Thread Lock 1342 (50 g))
Mount Case Cover
• Apply water resistant grease to oil seal (1).
: Grease 99000–25161 (SUZUKI Water
Resistant Grease (250 g))
• Install the gasket (2), dowel pins (3) and mount case
cover (4), then tighten seven cover bolts securely.
Lower Mount Cover
• Install lower mount cover (1) and cover bolts (2), then
tighten bolts, pre-coated with thread lock, to specified
torque.
Tightening torque
Lower mount cover bolt (a): 50 N·m (5.0 kgf-m,
36.0 lbf-ft)
2
(a)
1
IAJ611210064-01
3
4
(b)
3
IAJ611210065-01
2
3
3
IAJ611210066-01
1
4
IAJ611210067-01
1
(a)
2
IAJ611210068-01
Summary of Contents for GF60A
