Suzuki ACROSS 2020 Series, Owner'S Manual

Page: 472 / 600

469
7
7-3. Do-it-yourself maintenance
Mai
ntenanc
e and c
are
ters of your vehicle over those of other
vehicles
• Wheel with tire pressure warning
valve and transmitter installed is
inside or near the vehicle
If registration does not complete after
driving for 1 hour or more, perform the
ID code registration procedure again
from the beginning.
● If the vehicle is reversed during regis-
tration, the data up to that point is
reset, so perform the registration pro-
cedure again from the beginning.
● In the following situations, ID code
registration will not be started or was
not completed properly and the sys-
tem will not operate properly. Perform
the ID code registration procedure
again.
• If, when attempting to start ID code
registration, the tire pressure warning
light does not blink slowly 3 times.
• If, when the vehicle has been driven
for about 10 minutes after performing
ID code registration, the tire pressure
warning light blinks for approximately
1 minute and then illuminates.
● If ID code registration cannot be com-
pleted after performing the above pro-
cedure, contact a SUZUKI dealer or a
qualified workshop.
Your vehicle is equipped with tire
pressure warning system with the
function to have ID codes regis-
tered for a second wheel set, for
example a winter set. You can reg-
ister a second wheel set by your-
self, a SUZUKI dealer or a qualified
workshop.
After registration of a second wheel
set, either of these two wheel sets
can be selected for usage with the
tire pressure warning system.
■
Operating conditions for the
function
 This function will perform the
change of wheel set only if a sec-
ond wheel set has been regis-
tered. If no second wheel set has
been registered, no change will
be made when selecting this
function in the menu.
 Only a change between both
registered wheel set is possible,
mixing between these wheel sets
is not supported.
■
How to change between wheel
sets
1
Have the vehicle fitted with the
preferred wheel set.
2
Press or of the meter
control switches on the steering
wheel and select .
3
Press or of the meter
control switches and select
“Vehicle Settings”, and then
press and hold .
Selecting wheel set