Supero SUPER P6SLA, User'S And Bios Manual

Page: 32 / 91

2-7
Chapter 2: Installation
Removing the Pentium II Processor
When removing the Pentium II processor, avoid pressing
down on the motherboard or components. Instead,
press down on the plastic connectors.
To remove the Pentium II processor from the motherboard, follow
these steps (the reverse of the installation process).
1. Disconnect the fan power cable from the motherboard. It is
recommended to leave the cable connected to the processor.
2. Slide the clips on the supports backward to release the pegs
in the motherboard. Push the latches on the processor toward
the center of the processor until they click into place.
3. Lift one end of the processor until it is freed from Slot 1. Lift
the other end of the processor until it is freed from Slot 1. Lift the
entire processor (with the fan heatsink supports attached) until it
is free from the retention mechanism.
4. Remove the heatsink support pegs from the motherboard and
discard them. With one hand, squeeze together the two halves of
the peg on the bottom side of the motherboard. With the other
hand, pull the peg out of the hole in the motherboard. Do not
reuse the pegs.
!